Medine.co.uk

Cartrophen Vet 100 Mg/Ml Solution For Injection For Dogs

Revised: November 2014

AN. 00340/2014

SUMMARY OF PRODUCTS CHARACTERISTICS


1.

NAME OF THE VETERINARY MEDICINAL PRODUCT


Cartrophen Vet 100 mg/mL solution for injection for Dogs

2.

QUALITATIVE AND QUANTITATIVE COMPOSITION



Each ml contains:


Active substance

Pentosan Polysulfate Sodium 100.00 mg


Excipients

Benzyl Alcohol 10.45 mg


For the full list of excipients, see section 6.1

3.

PHARMACEUTICAL FORM


Solution for injection


A clear colourless to slightly yellow aqueous solution for subcutaneous administration.

4.

CLINICAL PARTICULARS

4.1

Target species


Dog

4.2

Indications for use, specifying the target species


For the treatment of lameness and pain of degenerative joint disease/osteoarthrosis (non-infectious arthrosis) in the skeletally mature dog.

4.3

Contraindications


Do not use for the treatment of septic arthritis. In this case, appropriate antimicrobial therapy should be instigated.


Do not use in dogs with advanced liver or kidney impairment, or evidence of infection.


Do not use in dogs with blood disorders, coagulation disorders, bleeding or malignancy (especially haemangiosarcoma). Pentosan polysulfate has an anticoagulant effect.


Do not use during the peri-operative period.


Do not use in the skeletally immature dog (i.e. dogs whose long bone growth plates have not closed).

4.4

Special warnings for each target species



A clinical effect may not be observed until after the second injection of the course of treatment.

4.5

Special precautions for use

i.

Special precautions for use in animals


Dogs should be weighed prior to administration to ensure accurate dosing.


Use with caution in dogs with history of pulmonary lacerations. Caution is also recommended in cases of hepatic impairment.


Do not exceed the standard dose. Increasing the recommended dose may result in exacerbation of stiffness and discomfort.


No more than 3 courses of 4 injections should be administered in a 12 month period.

ii.

Special precautions for the person administering the veterinary medicinal product to animals


Care should be taken to avoid accidental self-injection. In the event of accidental injection, seek medical advice immediately and show the package leaflet or label to the physician. Wash splashes from eyes and skin immediately with water. Wash hands after use.

4.6

Adverse reactions (frequency and seriousness)


Emesis, diarrhoea, lethargy and anorexia have been reported following the use of pentosan polysulfate. These signs may be the result of a hypersensitivity reaction and may require appropriate symptomatic treatment including antihistamine administration.


Administration of the product at recommended dose rates results in increases of activated partial thromboplastin time (aPTT) and thrombin time (TT) which may persist for up to 24 hours after administration in healthy dogs. This very rarely results in clinical effects, but because of the fibrinolytic action of pentosan polysulfate sodium, the possibility of internal bleeding from a tumour or vascular abnormality should be considered if signs develop. It is recommended that the animal should be monitored for signs of blood loss and treated appropriately


Bleeding disorders such as nasal bleeding, haemorrhagic diarrhoea and haematomas have been reported.


Local reactions such as a transient swelling have been observed post injection.

4.7

Use during pregnancy, lactation or lay


Laboratory studies in rabbits showed embryotoxic effects associated with a primary effect on the parent at repeated daily doses 2.5 times the recommended dose.


The safety of the product in the pregnant bitch has not been studied, therefore use is not recommended in these circumstances.


The product should not be used at the time of parturition due to its anticoagulant effects.


4.8

Interaction with other medicinal products and other forms of interaction


NSAIDs and in particular aspirin should not be used in combination with pentosan polysulfate sodium as they may affect thrombocyte adhesion and potentiate the anticoagulant activity of the product. Corticosteroids have been shown to be antagonistic to a number of actions of pentosan polysulfate sodium. Furthermore, use of anti-inflammatory drugs may result in a premature increase in the dog’s activity, which may interfere with the therapeutic activity of the product.


Do not use concurrently with steroids or non-steroidal anti-inflammatory drugs, including aspirin and phenylbutazone.


Do not use concurrently with heparin, warfarin or other anti-coagulants.

4.9

Amount(s) to be administered and administration route


Dosage: 3mg pentosan polysulfate sodium/kg bodyweight (equivalent to 0.3ml/10kg bodyweight) on four occasions, with an interval of 5-7 days between each administration.


Administration: By aseptic subcutaneous injection only of 0.3ml/10kg of bodyweight. An appropriately graduated syringe must be used to allow accurate administration of the required dose volume. This is particularly important when injecting small volumes.


Each case should be assessed individually by the veterinarian and an appropriate treatment program determined.

4.10

Overdose (symptoms, emergency procedures, antidotes), if necessary


Repeated daily overdoses of five times the recommended dose or more results in anorexia and depression, which are reversible upon withdrawal of the drug.


At overdose there may be hepatocellular damage and an associated, dose-dependent, elevation in ALT.


Increases in aPTT and TT are dose-dependent. At repeated doses greater than five times that recommended, these increases may persist beyond 1 week after administration in healthy dogs. Signs associated with these defects may include bleeding into the gastro-intestinal tract, body cavities and ecchymoses. At repeated doses greater than ten times that recommended there may be fatality as a result of gastro-intestinal haemorrhage.


If overdose occurs dogs should be hospitalised and observed and supportive therapy provided as deemed necessary by the veterinarian.

4.11

Withdrawal period(s)


Not applicable.

5.

PHARMACOLOGICAL PROPERTIES


Pharmacotherapeutic group: Anti-inflammatory and anti-rheumatic products, non-steroids




ATC Vet Code: QM01AX90

5.1

Pharmacodynamic properties


The product contains Pentosan Polysulfate Sodium (NaPPS), a semi-synthetic polymer with a mean molecular weight of 4000 Daltons.


In a model of osteoarthritis in dogs, when NaPPS was administered at similar to therapeutic doses, levels of metalloproteinases in cartilage were reduced and levels of tissue inhibitor of metalloproteinase (TIMP) increased, thereby preserving proteoglycan content and protecting cartilage matrix from degradation.


In dogs with osteoarthritis administration of NaPPS caused fibrinolysis, lipolysis and decreased platelet aggregability.


In in vitro studies and in vivo studies in laboratory species using doses above those proposed for therapeutic use, NaPPS suppressed levels of anti-inflammatory mediators and stimulated hyaluron synthesis from fibroblasts.

5.2

Pharmacokinetic properties


Absorption: In the dog, a peak plasma concentration of 7.40 g-eq pentosan polysulfate sodium/mL is achieved 15 minutes after subcutaneous administration.


Distribution: Pentosan polysulfate sodium binds many plasma proteins with a variable strength of association and dissociation resulting in a complex equilibrium between bound and unbound drug. Pentosan polysulfate sodium is concentrated in the liver and kidneys and reticuloendothelial system. Low levels occur in connective tissue and muscle. In studies carried out with rabbits, it has been shown that therapeutic concentrations of the active ingredient remain in the joint cartilage for 4-5 days after administration. The volume of distribution in dogs is 0.43L.


Biotransformation: Desulfation of pentosan polysulfate sodium occurs in the hepato-reticulo-endothelial system, the liver being the main site of activity. Depolymerisation may also occur in the kidney.


Elimination: The product is eliminated with a half life of approximately 3 hours in the dog. Forty eight hours after injection approximately 70% of the dose administered is eliminated via urine.

6.

PHARMACEUTICAL PARTICULARS

6.1

List of excipients


Benzyl alcohol

Disodium phosphate dodecahydrate

Sodium dihydrogen phosphate dihydrate

Sodium hydroxide

Hydrochloric acid

Water for injection.


6.2

Incompatibilities


The product should not be administered in the same syringe with other substances.


6.3

Shelf life


Shelf-life of the veterinary medicinal product as packaged for sale: 3 years

Shelf-life after first opening the immediate packaging: 3 months


6.4

Special precautions for storage


Do not store above 25°C. Keep the container in the outer carton in order to protect from light.


Following withdrawal of the first dose, use the product within 3 months. Discard unused material.

6.5

Nature and composition of immediate packaging


A 10 ml Type 1 clear glass vial fitted with a 20 mm rubber stopper and closed by a plastic flip off seal attached to an aluminium seal.

6.6

Special precautions for the disposal of unused veterinary medicinal product or waste materials derived from the use of such products, if appropriate


Any unused veterinary medicinal product or waste material derived from such veterinary medicinal product should be disposed of in accordance with local requirements.

7

MARKETING AUTHORISATION HOLDER


Arthropharm Europe Limited

50 Bedford St

Belfast

BT2 7FW

Northern Ireland

8.

MARKETING AUTHORISATION NUMBER


Vm 15519/4001

9.

DATE OF FIRST AUTHORISATION



Date: 7 September 2009


10.

DATE OF REVISION OF THE TEXT



Date: November 2014



Approved: 26/11/2014

Page 1 of 9